Fix a Stuck Cartridge

Here are some steps to fix a jammed cartridge.
The steps are:
• Soaking the print head surface with warm water, head cartridge likely clogged. So one of the easiest solution is to soak the entire surface of the print head with warm water, if necessary, use a toothbrush with soft bristles, do not be rough because it can cause the ink bubble expands.

• Surgical catridge. Follow the steps below:
1. Prepare equipment, such as ink bottles, syringes, kitchen knives, paper towels and duct tape.
2. Open the top cover of the ink with a knife, make sure the blade right on the stretch between the cover and body ink catridge. Cut open the fruit such as durian. You'll see a form of white cotton. Usually if you just bought is only a little ink. This proves that the producers do not just fill the maximum capacity ink cartridge.
3. Remove the cotton and soak into the liquid IPA or warm water to clean, do not forget to clean the printer ink tank also. Once clean, recharge by injection or meneteskannya. Do it slowly and it is recommended do not get too full (sekucupnya), so as not to flood.
4. Replace the cover and tighten cartridge, you can use glue or tape. Cartridge is ready for use.
• Boiling catridge with boiling water, if the above still fails the possibility of his case that bubble is not clogged, but the ink channel is in the catidgenya been frozen due to dried ink. Do Diagnostic cartridge, lift the cotton and soak into the liquid IPA or warm water to clean, do not forget to clean the printer ink tank also. Prepare clean water, then input all the devices catridge already dissected and cleaned into a clean container containing water, turn on the stove allow the water to a boil then turn off the stove wait until the water is warm. Once the water gets warm take catridge devices and wipe with clean cloth / dry. After that, do not forget to refill the ink in accordance with the color, try to put it back into the printer.

Source